INSTRUCTION MANUAL
Smart ZigBee LCD Temperature and Humidity Sensor E6

You will need Nous Smart Home App. Scan the QR code or download it from direct link

PRECAUTIONS

  • Read this manual carefully.
  • Use the product within the temperature and humidity limits specified in the technical data sheet.
  • Do not install the product near heat sources, such as radiators, etc.
  • Do not allow the device to fall and be subject to mechanical loads.
  • Do not use chemically active and abrasive detergents to clean the product. Use a damp flannel cloth for this.
  • Do not disassemble the product yourself - diagnostics and repair of the device must be carried out only in a certified service center.

Register with your mobile number/E-mail then login

ZigBee Hub/Gateway E1 is required

Know about the sensor

E6_manual_screen_1

Button

  • Enter configuration mode: Press and hold the button for 5 seconds until the screen blinks, the device will enter configuration mode
  • Shift C/F: Double-click to cycle switching between °С and °F temperature unit
  • Trigger to report: Single-click to report its current status to cloud server

E6_manual_screen_2

Screen

E6_manual_screen_3

On the back

E6_manual_screen_4

Quick Installation Guide

Note: the smart gateway must be added first before adding the sub-device.

1.Power on the sensor

1).Open the battery cover

E6_manual_screen_5

2).Insert the battery into the battery compartment
(please note battery positive and negative)

E6_manual_screen_6

3).Close the battery cover

E6_manual_screen_7

2.You will need Nous ZigBee GateWay/Hub. Open “Nous Smart Home” app, Enter the gateway homepage and click “Add subdevice”

E6_manual_screen_8

3.Press the reset button for 5 seconds, till the screen blink, then click the confirm button which shows and "LED already blink" follow the in-app instructions to connect the sensor to your gateway.

E6_manual_screen_9

E6_manual_screen_10

4.Waiting for a few seconds, This device is added successfully and you may rename it. Click “Done” to finish the setting.

E6_manual_screen_11

5.Put it where you need it.
6.Nous Smart Home app settings:

1).The temperature unit setting

E6_manual_screen_12

E6_manual_screen_13

2).The temperature update sensitivity setting

E6_manual_screen_14

E6_manual_screen_15

3).Limits setting of Low temperature alarm and High temperature alarm.

E6_manual_screen_16

E6_manual_screen_17

4).Enable/disable alarm setting

E6_manual_screen_18

E6_manual_screen_19